...
To allow for changes to the variation amount you must change the configuration of the Variation document type.
How to configure a Variation so it's value can be changed after a claim
1. Go to Configure
2. Document types
3. Select the Variation document type you wish to update
4. On the right-hand screen scroll to this section
5. Tick the "Can edit the value of Variations after a Claim"
6. 
...
This is enabled by the Administrator of your project. (Administrator click here).
Change the Value of a Variation After a Claim Has Been Made
1. After the above option has been turned on you can edit the value of the Variation by responding to it.
2. You can then edit the value
| Tip |
|---|
Please note that you can only change the value of the Variation to an amount greater than its current claimed amount For eg: the Value of your variation is $5000 and you have claimed $2000 against this Variation, you can change the Variation to any value, greater or equal to $2000. You cannot change the value to anything less than $2000. |
In the example below there is a Variation for $2300.
A claim has been made against it for $1500.
When trying to change the Variation amount to 1000, the system shows you the Warning/Error message.
What
...
...
...
Additional Status Action Button config criteria for CA forms
"Matches Assessment" allows the status action button configuration of CA forms.
When configured, you can use it to hide/show buttons based on whether the assessment amount of a variation is equal to the total of the variation
If the amount is the same the system will dynamically update the list of status action buttons and display them when changing the assessment amount on a variation.
...