Check Project Details
Please note you need to be a Project Administrator to change Project Details.
If you have questions please contact iTWO cx Support or speak to your Account Manager.
Once your iTWO cx Project has been created by the RIB Account Manager you can confirm that the Project Details have been entered correctly by going into.
- Configure.
- Project Details.
If the details are correct. Click Submit.
If not - speak to your Account Manager or directly change them and click Submit.
Project Name
Enter the project number and name as known inside the project team.
Phone / Fax / Postcode
Enter the primary contact details of the project. These details are displayed with the project details at the top of all forms in iTWO cx.
The email address is system generated. You cannot change this.
Version
Cannot be changed.
Language
Select the default language used on this project. All new users created after this change will have this default language. Existing users will need to change their language options under their Contact Details (Click here).
Time Zone
This is the time zone of the project measured in hours offset from Sydney Australia time.
Administrator
The Project Administrator(s) are defined here. Project Administrator(s) are the only users that have access to the Configuration Module.
Supported By
Nominate the UserID(s) of who should be contacted as the primary support person for this project.
Help Desk
Specify the default Help Desk telephone number for this Project. The iTWO cx Help Desk is the default number set.
Contact Name and Email Address
Customise the contact name and email address that appears at the bottom of a standard iTWO cx email notification.
This only applies to the standard (e) notification emails. It does not apply to the Preview Email notifications.
